Search results for "Transfer function" - Rhea

Create the page "Transfer function" on this wiki! See also the search results found.

• News
  * May, 2009: Zach finished the transfer of the remaining pages from the Old Kiwi as an exercise in learning Rhea fo * January 12, 2009: The "recent changes by category" function has been enabled. You can use it to list the changes that relate to a speci
  10 KB (1,507 words) - 04:36, 24 August 2011
• HW4.4 Tyler Houlihan ECE301Fall2008mboutin
  ...laplace transform of this function to get <math>H(s)\,</math>, the system function. My original function:
  1 KB (235 words) - 15:29, 25 September 2008
• Tyler Houlihan: Chapter 7 Notes ECE301Fall2008mboutin
  We can use a transfer function to approximate this filter, and it is: This isolates the range, and if the convolution was ideal, this function should only have a value when k=0, which would yield:
  3 KB (543 words) - 17:23, 10 November 2008
• Peer Legacy ECE202
  *Be sure to get the full story on the dirac function, convolution, bode plot approximations, and linearity. Don't rely on memori ...nsed and that made it more focussed towards laying foundation for ECE 301. Transfer functions, Laplace domain analysis, Convolution etc. are concepts used in a
  7 KB (1,297 words) - 11:41, 10 December 2011
• Student summary speech
  ...language and have different accents and because the phonemes have the same function. The end result after modeling is a transfer function that is an all-pole filter with a gain and a time delay.
  5 KB (841 words) - 15:26, 10 April 2013
• SupplementarySpeech prelecture
  - Going through tube delays the signal (show function) - between tubes (show function)
  2 KB (390 words) - 07:46, 14 November 2011
• SupplementalSpeech prelecture
  - Going through tube delays the signal (show function) - between tubes (show function)
  2 KB (387 words) - 07:47, 14 November 2011
• Snikitha ListECE202
  ...d average power, complex power, power factor correction, and maximum power transfer. Instantaneous and average power. <br/><br/> i. an ability to define and explain the meaning/function of charge, current, voltage, power, energy, R, L, C, the op amp, and the fu
  6 KB (873 words) - 17:02, 15 April 2013
• Lecture32ECE438F10
  ...length connected to a tube of zero diameter. We observed that the transfer function of such a system is an all pole filter cascaded with a time delay. The pole
  1 KB (151 words) - 12:53, 8 November 2010
• Hw5ECE438 discussion
  ...pulse response just be the convolution of a unit impulse with the transfer function ho(t) (given on pg 521 fig 7.7 of Oppenheim-Willsky)?
  1 KB (159 words) - 03:56, 29 September 2010
• Lecture20ECE438F10
  ...ystems, which led us to the concepts of "Frequency Response" and "Transfer function" of a system. We then defined a simple filter with low-pass characteristics
  867 B (122 words) - 16:21, 8 October 2010
• Lecture22ECE438F10
  ...oles/zeros with either representation (using a change of variable when the function is in terms of 1/z). We then began talking about systems defined by differe
  2 KB (393 words) - 07:25, 25 October 2010
• Hw7ECE438F10
  Obtain the frequency response and the transfer function for each of the following systems: Consider a causal LTI system with transfer function
  4 KB (661 words) - 11:22, 30 October 2011
• Lecture23ECE438F10
  ...ich the frequency response is well defined, then the poles of the transfer function should all be inside the unit circle in the complex plane.
  2 KB (329 words) - 12:04, 18 October 2010
• ECE438 Week9 Quiz
  The transfer function for this filter is given by <math> H(z) = (1-e^{j\theta}z^{-1})(1-e^{-j\the
  3 KB (480 words) - 10:42, 11 November 2011
• Lecture24ECE438F10
  ...e, we continued talking about filters and filter design using the transfer function. It seems like many students find it difficult to see the point of this stu
  1 KB (174 words) - 03:53, 21 October 2010
• Practice Question 5 ECE438F10
  * Transfer function
  2 KB (322 words) - 13:00, 26 November 2013
• ECE438 Week10 Quiz
  :a. Compute the transfer function <math>H(z)</math>, and find its poles and zeros. a. Compute the transfer function. Plot the zero-pole graph of H(z) and declare the ROC.
  3 KB (479 words) - 10:42, 11 November 2011
• ECE438 Week10 Quiz Q4sol
  ...ilter represented by this difference equation is IIR. Because the transfer function has one non-zero pole that is not cancelled out by any zero.
  2 KB (441 words) - 05:42, 28 October 2010
• ECE438 HW7 Solution
  ...between the DFT and the Fourier series coefficients of continuous periodic function x[n]? <br> The DFT of a sampled signal x[n] of length N is directly proport Function's period N = 3, <br> Using IDFT, <br> <math>\begin{align}
  19 KB (3,208 words) - 11:23, 30 October 2011