Revision as of 19:10, 10 November 2012 by Green26 (Talk | contribs)

Determining Orientation from Accelerometer (alec green)


OUTLINE
. introduction
. continuous equations (..to be completed..)
. discretization (..to be completed..)
. references

Introduction

An accelerometer is useful for measuring orientation relative to Earth's surface ground ('static acceleration' due to gravitational force) or accelerating motion throughout space ('dynamic acceleration' due to non-gravitational force such as a car speeding up or a human shaking an accelerometer-clad device). However, note that accelerometers are implicity restricted to measuring acceleration, and cannot measure velocity. For example, constant nonzero velocity will produce same measurement as zero velocity.

It's important to first determine if an accelerometer is appropriate for your application. If you're not sure, you may consider other orientation/position sensing devices such as: gyroscope (angular velocity), magnetic compass (2D direction of maximum local magnetic field), magnetometer (magnitude and 3D direction of local magnetic field), GPS (geospatial location).

In order to achieve higher-level measurements such as 'dead reckoning' (calculation of position and orientation in 3D space), you will need to combine sensor readings (eg accelerometer + gyro + magnetometer). This 'sensor fusion' also allows for inter-recalibration among sensors such that measurement 'drift' of certain sensors (esp. gyroscope) is minimized, and can further benefit from probabilistic noise-reducing filters such as the Bayesian or Kalman filter.


Continuous Equations

It's instructive to read through pages 3-4 of [2] in order to understand how an accelerometer works on a physical level, but not necessary to interpret the analog or digital signals generated from the sensor.


Discretization

For reasons to soon be discussed, computing the above arctangent equations on an HCS12 microcontroller is non-trivial.

Based on [3], I considered two atan implementations:

  • 'closed form' (finite number of terms) approximation
  • lookup table (LUT) interpolation

The atan function you might normally invoke from the <math.h> library requires floating point numbers. An example implementation can be seen here [3].

Fixed-point (as opposed to floating point) processors like the HCS12 used in ECE 362 at Purdue make it difficult to deal with functions like arctangent because the dynamic range (ratio of max measureable qty : min measurable qty) is small. To make this notion explicit, suppose we are given 2 8-bit unsigned integer values 73 and 139 which we know should lie within the closed range [0,255]. Now, suppose these values represent the non-hypotenuse sides of a right triangle and we would like the calculate one of the right triangle's angles with the closed form approximation described above. One such angle could be arctan(73/139) ~= (73/139)^2 / (1+ .28125*(73/139)^2)

References

[1] Freescale Semiconductor, "±1.5g, ±6g Three Axis Low-g Micromachined Accelerometer" Freescale Datasheet. <http://www.sparkfun.com/datasheets/Components/General/MMA7361L.pdf>

[2] L. Salhuana, "Tilt Sensing Using Linear Accelerometers," Freescale Application Note. <http://www.freescale.com/files/sensors/doc/app_note/AN3461.pdf>

[3] A. Ukil et al., "Fast Computation of arctangent Functions for Embedded Applications: A Comparative Analysis," IEEE ISIE 2011. <http://ieeexplore.ieee.org/xpls/abs_all.jsp?arnumber=5984330>

[4] Apple Open Source, "atan.c" <http://opensource.apple.com/source/Libm/Libm-315/Source/Intel/atan.c>

Alumni Liaison

Prof. Math. Ohio State and Associate Dean
Outstanding Alumnus Purdue Math 2008

Jeff McNeal