(New page: Category: ECE Category: ECE 301 Category: Fall Category: 2007 Category: mboutin Category: Examples Category: Aliasing Category: Animated As shown in the [[...) |
|||

Line 16: | Line 16: | ||

: Since the sampling frequency is greater than the Nyquist Rate (The frequency is actually 10 times that of the spinning frequency), then our signal should be able to be reconstructed. | : Since the sampling frequency is greater than the Nyquist Rate (The frequency is actually 10 times that of the spinning frequency), then our signal should be able to be reconstructed. | ||

− | [[Image: ECE 301 Fall 2007 mboutin Strobe_01_01.gif]] | + | [[Image: ECE 301 Fall 2007 mboutin Strobe_01_01.gif|center]] |

Case 2: Sampling Frequency (Strobe Light Frequency) = .2 samples/sec (Strobe Flashes Once every 5 Seconds) | Case 2: Sampling Frequency (Strobe Light Frequency) = .2 samples/sec (Strobe Flashes Once every 5 Seconds) | ||

Line 22: | Line 22: | ||

: Since the sampling frequency is the same as the spinning wheel frequency, (less than the Nyquist Rate) we can expect the motion of the wheel to not be reconstructed properly. Since the sampling frequency is the same as the frequency of the spinning wheel, the wheel appears to be motionless, even though it is still spinning at .2 rev/sec. | : Since the sampling frequency is the same as the spinning wheel frequency, (less than the Nyquist Rate) we can expect the motion of the wheel to not be reconstructed properly. Since the sampling frequency is the same as the frequency of the spinning wheel, the wheel appears to be motionless, even though it is still spinning at .2 rev/sec. | ||

− | [[Image: ECE 301 Fall 2007 mboutin Strobe_01_02.gif]] | + | [[Image: ECE 301 Fall 2007 mboutin Strobe_01_02.gif|center]] |

Case 3: Sampling Frequency (Strobe Light Frequency) = 2/9 samples/sec (Strobe Flashes Once every 4.5 Seconds) | Case 3: Sampling Frequency (Strobe Light Frequency) = 2/9 samples/sec (Strobe Flashes Once every 4.5 Seconds) | ||

Line 30: | Line 30: | ||

Note: Watch Carefully, the dot moves very slowly | Note: Watch Carefully, the dot moves very slowly | ||

− | [[Image: ECE 301 Fall 2007 mboutin Strobe_01_03.gif]] | + | [[Image: ECE 301 Fall 2007 mboutin Strobe_01_03.gif|center]] |

## Revision as of 12:32, 12 December 2008

As shown in the Sampling Theorem entry, a signal must be sampled greater than the Nyquist Rate in order to reconstruct the original signal. The effect of undersampling, or sampling at a rate below that of the Nyquist Rate, is aliasing. The example used in class was that of a spinning wheel.

Below is an animation that shows the spinning wheel example in greater detail. The wheel is spinning in the clockwise direction at a rate of 5 sec/rev which corresponds to a frequency of .2 rev/sec. This frequency is the frequency of the signal. The small red dot is just an indicator on a part of the wheel to make it easy to see how the wheel is spinning. In each of the following three cases, the wheel is observed at snap shots in time by using a strobe light. Each case has a different strobe light frequency. This frequency is our sampling frequency.

Case 1: Sampling Frequency (Strobe Light Frequency) = 2 samples/sec (Strobe Flashes Once every .5 Seconds)

- Since the sampling frequency is greater than the Nyquist Rate (The frequency is actually 10 times that of the spinning frequency), then our signal should be able to be reconstructed.

Case 2: Sampling Frequency (Strobe Light Frequency) = .2 samples/sec (Strobe Flashes Once every 5 Seconds)

- Since the sampling frequency is the same as the spinning wheel frequency, (less than the Nyquist Rate) we can expect the motion of the wheel to not be reconstructed properly. Since the sampling frequency is the same as the frequency of the spinning wheel, the wheel appears to be motionless, even though it is still spinning at .2 rev/sec.

Case 3: Sampling Frequency (Strobe Light Frequency) = 2/9 samples/sec (Strobe Flashes Once every 4.5 Seconds)

- In this case, the sampling frequency is higher than that of the frequency of the spinning wheel, but it is again below the Nyquist Rate, so we can expect the motion of the wheel to not be reconstructed properly. Since the sampling frequency is slightly greater than the wheel's frequency, the wheel appears to be spinning backwards.

Note: Watch Carefully, the dot moves very slowly